Siemens WG44G2MG0, User Manual And Installation Instructions

Page: 38 / 52

en
Troubleshooting
38
Fault Cause and troubleshooting
"E:36 / -10" The pump cap is not fully screwed in.
▶
Ensure that the pump cap is screwed in all the way
into the appliance. The handle on the pump cap
must be in a vertical position.
"E:36 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drain pump", Page 33
"E:38 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drum", Page 32
if the fault is displayed again,
▶
→ "Cleaning the drain pump", Page 33
Inlet opening of the rubber gasket is blocked.
▶
→ "Cleaning the intake opening in the rubber gas-
ket", Page 36
The water pressure is low.
No remedial action possible.
The filter in the water inflow is blocked.
▶
Clean the water inflow filter.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
"E:35 / -10" There is water in the base trough.
▶
Turn off the water tap.
▶
Call the after-sales service.
→
"Customer Service", Page 47
The appliance is leaking.
▶
Turn off the water tap.
▶
Call the after-sales service.
→
"Customer Service", Page 47
lights up. The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 31
Water level is too high.
▶
Start the
Abpumpen
programme.
Laundry is caught in the door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.