Appendix
08.90
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
176
177
178
179
No block data
Missing position/feed rate
Order of Start/Stop
Block number not permitted
MDI: No position
MDI: No feed rate
No block number for single block
Number of blocks per program not permitted (i.e. > 40)
Reserve
Absolute programming with roll feed
Deceleration value = 00
Selected jog speed = 00
Feed rate = 00 (or caused by acceleration 00)
Reference point approach speed 1 = 0
Reference point approach speed 2 = 0
Reference point approach speed 3 = 0
Both directios selected (TIP + /-)
No direction selected (TIP +/-)
Direction selection changed during traversing
Program number = 0
No program number
No block data available
First G-Function not permitted
Second G-Function not permitted
Third G-Function not permitted
Fourth G-Function not permitted
Deactivation of tool offset although not active
Last block in a program must not be skipped
Deactivation of zero offset although not active
Program number not valid for this axis
Subroutine level not permitted
”Setting of actual value” already active
”Setting of actual value” not yet active
Reserve
Pre-limit switch negative (MD 11)
Pre-limit switch positive (MD 13)
The present process parameters were not saved
The block list in the RAM was not saved
Hardware version < 2: simultaneous homing is not possible
Buffer number not permitted
Buffer number not released
Jump back buffer -1 not permitted
Jump 1 not permitted
Fault
no.
Explanation
6 - 4
©
Siemens AG 1990 All Rights Reserved 6ZB5 440-0JB02
WF 725/WF726 (PJ – NC Auxiliary axis and Tool magazine for SINUMERIK 3GA4)
