13
de
en
Before using
for the first time
General
Fill the water tank with fresh, uncarbonated
water only, and if possible, use only beans
for fully automatic coffee and espresso
machines. Do not use coffee beans that
have been glazed, caramelized or treated
with other additives containing sugar, since
they will block the grinding unit. Check the
water hardness with the enclosed test strip.
If a value other than 4 is displayed, change
the setting on the appliance accordingly
(see “Setting the water hardness”).
Switching on the appliance
● Place the appliance on a flat, water
resistant surface.
● Pull enough of the power cord out of the
storage compartment and plug it into the
electrical socket.
● Remove and rinse the water tank
13
and fill it with fresh cold water. Do not fill
above the “max” mark.
● Replace the water tank
13
and push it
firmly downward into place.
● Fill the bean container with coffee beans.
● Make sure that the hot water/steam dial
8
is at
●
.
● Set the power on/off switch
1
to
I
.
When switched on for the first time, the
water pipes in the appliance must be filled.
● Place a cup under the nozzle
9
.
● Turn the dial
8
to
g
/
h
. Water runs into
the cup. Turn the dial
8
back to
�
.
● The LED
eco
will now flash red. The
appliance rinses and heats up.
The appliance is
ready for use
when all
four buttons
4
,
5
,
eco
,
h
and the coffee
strength indicator (coffee beans) light up on
the display.
This appliance also offers an “
eco
” mode
which uses less power.
Coffee or steam can be dispensed in the
usual way when the appliance is in “
eco
”
mode. When the required button is pressed,
the appliance first heats up, so it will take a
little longer until the coffee is brewed or the
machine is ready to provide steam.
To dispense hot water, first press the
eco
button. The appliance heats up briefly. Now
the hot water can be dispensed as usual.
i
The appliance’s factory settings are
programmed for optimal performance.
Note:
If the appliance is being used for the
first time or has not been operated for a
prolonged period, the first cup of coffee will
not have the full aroma and should not be
consumed.
Controls
1 Power on/off switch
The power switch
1
on the rear of the appli
ance switches the power supply on or off.
When the power on/off switch has been
turned on, the appliance heats up, rinses
and is then ready for use.
The appliance does not rinse if it is still
warm when switched on.
Warning
Do not turn off the power switch while the
appliance is operating. Before switching off,
press the eco button to start the automatic
rinse cycle. Then switch off at the power
on/off switch.
Dial for adjusting the amount of coffee
per cup
This dial
allows variable adjustment of the
quantity of coffee from a small cup
E
to a
large cup
F
.
