Siemens SPD4tel, User Manual

Page: 12 / 16

6
User Manual - Canada
DO NOT INSTALL DURING ACTIVE
STORM CONDITIONS.
This device can be used indoor (SPD4tel),
or outdoor when installed in weatherproof
housing(SPD4telkit). Failure to follow
installation instructions can result in personal
injury and/or equipment damage not covered
by warranty.
SPD4tel – For indoor use:
▪
SPD4tel protects 2 pairs (1 pair per
protector module) and is intended for
indoor use only, without additional
housing.
▪
Attach securely to mounting surface.
▪
Install ground wire, and if applicable,
service shield, under top center nut
of mounting bracket and tighten nut
securely.
▪
Connect one pair (tip and ring) under
the bottom nut on each protector
module, tip on one post, ring on the
other.
▪
Connect the customer wiring, tip and
ring, under the top nut on the same
protector module (protector is wired in
parallel)
▪
Check all wiring for loose connections
and shorting or broken wires.
SPD4telkit – For outdoor use:
▪
Mount weatherproof housing securely
to flat surface.
▪
Conductors will enter and exit from the
flexible grommet located at bottom of
enclosure.
▪
Follow instruction above for SPD4tel
connections.
▪
Secure enclosure with tie wrap or
similar locking device.
▪
The SPD4telkit is a Parallel Device.
Installation Instructions:
Telco Side Cable
Terminate Between
Washers
Ground Clip
Customer Side
Cable
Terminate Between
washers