User programming via the keypad
6
Setting and unsetting the system
15
Siemens AB
A6V10209178
Security Products
26.09.2011
1 UNSET
Performs an Unset on the system. If multiple areas are defined then each area is
presented in a sub-menu. For a single area system this option is only presented
when the system is Set.
2 FULLSET
Performs a Fullset on the system. If multiple areas are defined then each area is
presented in a sub-menu. For a single area system this option is only presented
when the system is Unset.
3 PARTSET A
Performs a Partset A on the system. If multiple areas are defined then each area
is presented in a sub-menu.
4 PARTSET B
Performs a Partset B on the system. If multiple areas are defined then each area
is presented in a sub-menu.
6.1.1
UNSET
To UNSET the system:
1. Enter a valid user code.
The keypad displays a prompt to unset the system.
2. Press SELECT.
The keypad display indicates that the system is unset on the bottom line of
the display for approximately 5 seconds. After this time has elapsed, the
bottom line is cleared.
3. If the alarm has been activated, enter the user code.
All bells and strobes are silenced.
The message PANEL DISARMED displays on the keypad for
approximately 5 seconds.
The source of the alarm condition displays on the keypad and the Alert
LED flashes.
The keypad continues to display the alert until the alert is restored.
6.1.2
FULLSET
The FULLSET option provides the following functionality:
Full protection to a building (opening of alarm zones activates alarm)
Opening of entry/exit zones starts the entry timer. If the alarm is not unset
before the entry timer expires, the alarm is activated
To select the FULLSET option:
1. Scroll to FULLSET.
2. Press SELECT.
The second line displays the exit time and the buzzer sounds to indicate that
the user should exit the building.
When the system has been fully set, the LCD displays SYSTEM FULLSET on
the bottom line for approximately 10 seconds.
