en
6
Water softening system
To ensure good washing results,
the dishwasher requires soft water,
i.e. containing low amounts of lime,
otherwise white limescale will be
deposited on the utensils and inner
container.
Tap water above 7
_
dH (from set value
) must be softened.
The water is softened with salt
(regeneration salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree
of hardness of your tap water (see table).
Set
The amount of salt dispensed can be set
from
to
.
Sal is not required at the set value
.
Find out about the hardness value
of your tap water. Your water supply
company will assist you.
Set value can be found in the water
hardness table.
Close the door.
Switch on ON/OFF switch
1
.
Hold down programme button A
and press START button
6
until on
the digital display is indicated
.
Release both buttons.
The LED for button A flashes and
the digital display displays the factory
setting
.
To change the setting,
press programme button C .
Each time the button is pressed, the set
value increases by one level; when the
value of
has been reached, the
display jumps back to
(off).
Press START button
6
.
The chosen setting has now been
stored.
Water hardness table
_
Downloaded from DishWasher-Manual.com Manuals
