12
SFIDK.PS.022.Q5.02
4.4.2 Connection of transducer cables
SITRANS FUS380 and FUE380 is supplied with 4 separate cables.
Cables can be used on all transducers. (The cables are not paired with a specific transducer).
Snap out the connection plate and loosen grounding wire.
Cables are ok manufactured with crimp on cable ends.
Smoothly push the cables one by one from underneath the base through the glands and adjust
all four cable ends approximately 100 mm from the upper frame of the base (see figure).
4.4.1 Installation of wall/pipe bracket
1. Loosen the 2 screws on each side of the unit and remove the transmitter.
2. Mount the wall bracket in an appropriate place taking the coaxial cable length into con-
sideration, and allowing adequate space for cable inlets underneath and on both sides.
4.4
Installation of the transmitter, remote version
Fig. 2
Fig. 3
Fig. 1