Document No. 565-722
Installation Instructions
August 2, 2013
Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as
design improvements are introduced. APOGEE, Insight, and SiPass are registered trademarks of Siemens Industry, Inc. Other product or
company names mentioned herein may be the trademarks of their respective owners. © 2013 Siemens Industry, Inc.
Siemens Industry, Inc.
Building Technologies Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
USA
Tel. 1 + 847-215-1000
Your feedback is important to us. If you have
comments about this document, please send them
Document No. 565-722
Printed in the USA
Page 2 of 2
Prerequisites
Driver hardware is installed according to its
respective installation instructions.
FLN termination blocks are installed.
One 115V or 230V receptacle (depending on
device) is available to power the Trunk Interface
II.
Ethernet infrastructure is installed.
Depending on the type of installation, other
prerequisites may have to be completed.
Connecting the Driver to the SiPass
System
Follow these steps to connect the driver to the SiPass
System:
1. Install the Trunk Interface II per the diagram in
Figure 1.
2. Connect cables per the diagram in Figure 1.
3. Plug in the power supply for the Trunk Interface II
per the diagram in Figure 1.
Figure 1: Connecting the Driver to the SiPass System.
Table 1. Wiring Pin-outs for RS-232 Cable
(P/N 536-004).
Trunk Interface
(DB-25 Male)
SiPass
(9-pin Female)
2
3
3
2
7
5
20
4
