Siemens SIMOTICS XP 1MD4, Operating Instructions And Installation Instructions, Page: 43 / 128

5.2 Lift the machine to where it will be installed, and position it
5.2.1 Preconditions for correct alignment and secure attachment
Detailed specialist knowledge of the following measures is required in order to correctly align
and securely fit the equipment.
● Preparing the foundation
● Selecting and mounting the coupling
● Measuring the concentricity and axial eccentricity tolerances
● Positioning the machine
If you are not familiar with the prescribed measures and procedures, then you can make use
of the services offered by the local Service Center.
5.2.2 Checking the load handling attachments
Inspect the load handling attachments such as the load stands, lifting eyes and ring bolts and
also the lifting gear, before lifting the machine:
● Inspect the load handling attachments on the machine for possible damage. Replace any
load handling attachments that are found to be damaged.
● Check before use that the load handling attachments are correctly secured.
● When lifting the machine, use only approved and undamaged lifting gear of sufficient rated
capacity. Check these before using them.
WARNING
The machine can be dropped
If the load handling attachments and lifting gear are damaged or not correctly secured,
the machine may be dropped during lifting. This can result in death, serious injury or
material damage. Inspect the load handling attachments and lifting gear before use.
5.2.3 Lifting and transportation
● Persons driving cranes and fork lift trucks must hold appropriate qualifications.
● When lifting the machine, use only approved and undamaged sling guides and spreaders
of sufficient rated capacity. Check these before using them. The weight of the machine is
stated on the rating plate.
Assembling
5.2 Lift the machine to where it will be installed, and position it
SIMOTICS XP 1MD4/1MD5
Operating Instructions 05/2015
43