Preparation for use
3.2 Transport and storage
Naturally cooled 1FW6 built-in torque motors
48
Operating Instructions, 07/2017, 6SN1197-0AF02-0BP2
3.2
Transport and storage
Note
UN number for permanent magnets
UN number 2807 is allocated to permit magnets as hazardous item.
NOTICE
Damage to the motor when incorrectly lifted
Improper use of lifting devices can cause plastic deformation of the motor.
•
To lift the motor (or stator/rotor), at least three lifting eyebolts are required.
•
Screw the lifting eyebolts symmetrically into the tapped holes on the flat motor
(or stator/rotor).
•
Only lift motors (or stators/rotors) when they are in a horizontal position.
•
The lifting ropes must be the same length. The tightened lifting ropes must form an
angle of at least 50° between the lifting rope and motor (or stator/rotor).
WARNING
Risk of toppling over
Motors, stators, and rotors must not be stacked too high – risk of death, personal injury
and/or material damage.
•
Never stack packed or unpacked motors, stators or rotors on top of one another.
•
Only transport and store motors, stators and rotors in the horizontal position.
•
Observe the safety instructions and handling on the packaging.
The rotor is secured in the stator by means of transport locks, and is protected by spacer
film. The original packaging for the built-in torque motor and the transport locks (incl. the
screws) are required for storage/transport purposes and should, therefore, be kept in a safe
place.
