Device maintenance and repair
7.4 Removing and installing hardware
SIMATIC IPC547G
126
Operating Instructions, 04/2020, A5E49948632-AA
7.4.8
Replace the adapter module for the removable tray
Requirement
●
The device is equipped with the drive cage type A.
●
The device is fully disconnected from the mains voltage; see section "Switching off the
●
The device is open; see section "Open the device (Page 76)".
●
All slot covers and removable trays have been removed.
Procedure
Removal
1.
Note the assignment of all SATA cables and detach all the SATA cables
①
.
2.
Unlatch the adapter module for the removable rack unit by firmly pressing on the latches
②
in the direction of the arrow and pressing on the ejector
③
.
3.
Loosen the unlatched adapter module
④
by rotating it upwards from the brackets and
take it out of the drive cage.
Installation
1.
Insert the new adapter module for removable rack unit
④
into the drive bay from the front
and snap it into place at the back, see section "Installing a hard disk drive or SSD in slot 0