Siemens SIMATIC HMI SICALIS PMC 7, Equipment Manual

Page: 22 / 78

Installation
2-10
SICALIS PMC 7 Operator Panel Equipment Manual
Release 09/00
Windows NT Settings
When starting up the second time, the system will identify itself as Windows NT
Workstation 4.0 with Service Pack 5.
1. In the Logon Information dialog logon as Administrator with the password
simatico
and confirm with
OK
.
2. Read the
README.TXT
file. The file contains the most up-to-date information
about SIMATIC PC. Afterwards, close the MS-DOS window.
3. Close the
Welcome dialog by clicking on
Close .
4. Next the display driver will be automatically installed. In the Control Panel under
Adapter Type select: Chips Video Accelerator from Chips and Technologies.
You can also make these changes manually (see point 8.)
Note
Please do not interrupt the process while the display driver is automatically
installed.
5. The system will automatically restart.
6. After the third startup in VGA mode, the system will report at logon that
The
system could not log you on ...
Acknowledge with
OK
and logon as
described in point 1. with the password
simatico
.
7. Watch the further automatic configuration of the display. At the end confirm with
Yes
that the test image has been displayed properly.
8. Under Display Properties, check that the Display Type is set correctly. To do so,
open the Control Panel via the Start menu.
Manual Installation of the Display Driver:
Under Adapter Type select: Chips Video Accelerator from Chips and
Technologies.. Select Change and then in the directory
C:\Display
the file
oemsetup.inf
. Further information can be found in the Windows NT
documentation.
9. Once the correct display type has been selected and the associated driver
installed, you can now select a resolution of 800 x 600 pixels (SVGA) with
65535 colors. Test the new settings and confirm with
OK
. If necessary, restart
the system.