Siemens SIMATIC CM35, Manual

Page: 44 / 144

3-21
CM35 Counter Module
(4) J31069-D0416-U001-A5-7618
The operating mode of the CM35 must have already been set during configu-
ration. Proceed as shown below.
1. In the configuration table, select the line with the CM35, and click the
button Param. ...
2. In the dialog box ² Parameterize..., ² select the field under ² Value ² in the
first line of the table (5), and click the Select... button. In the next dialog
box which appears, select the desired operating mode, and confirm with
OK .
3. Repeat this step in the second line of the table (8) with the same operating
mode. See figure 3-5.
4. In the ² Parameterize... ² dialog box, click the OK button, and close the
configuration table with OK .
Figure 3-5 Setting the operating mode with COM PROFIBUS
Note
When distributed integration into the SIMATIC S5 is used, only the operat-
ing modes
² period duration measurement ² and ² timer ² (time generator) are
permitted. See chapter 1.2.
For additional preparations before operation, see the manual of COM PROFI-
BUS.
Setting the
operating mode
Commissioning
Commissioning