en
44
44
Installation
In order to function correctly the
dishwasher must be properly installed.
Specifications for the water intake and
waste-water drainage, as well as electrical
connections, must fulfil the criteria that are
set out in the following paragraphs and the
installation instructions.
When installing the dishwasher, carry out
tasks in the following order:
– check contents of delivery upon receipt,
– site dishwasher,
– connect drainage hose,
– connect inlet hose to water supply,
– connect dishwasher to electricity supply.
Checking contents of delivery
All functions of your dishwasher have
been thoroughly tested in the factory. A
small number of water marks have been
left on the dishwasher as a result. They
disappear as soon as the appliance is
used for the first time.
Siting the dishwasher
Dimensions associated with siting the
dishwasher are contained in the
installation instructions. Ensure that the
appliance is completely level by adjusting
the feet. Make sure that it is standing on a
firm surface.
Drainage connection
See the installation instructions for details
of procedure to be followed.
If necessary, fit a siphon trap (U-bend) with
a connecting piece for the drainage hose.
Connect the drainage hose to the trap
using the enclosed parts.
Fresh-water connection
Connect the inlet hose to a water tap using
the enclosed parts and in accordance with
the installation instructions.
Water pressure:
Minimum 0,5 bar – maximum 10 bar.
If the water pressure is higher, install a
pressure reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend that you use cold water.
If you do use hot water, the temperature
should not exceed 60
°
C.
Electrical connection
This appliance should only be connected
to a 230/240 V AC source via a properly
installed earthed socket. See nameplate
31
for size of required fuse.
The socket must be installed close to the
dishwasher.
If you need to extend the mains
connecting lead, do not cut off the plug.
Replace the whole cable, which can be
disconnected at the junction box on the
rear of the appliance.
If the domestic wiring includes a residual-
current-operated (FI) circuit-breaker, make
sure that it bears the
mark, as only
this type conforms to the latest regulations
Disconnecting the dishwasher
Here too, it is important that tasks are
carried out in the correct sequence:
always unplug the appliance from the
mains electricity first of all.
Pull plug out of wall socket.
Turn off water supply.
Disconnect drain and water input hoses.
Remove screws in underside of work
surface. Detach base board, if fitted.
Pull out appliance and carefully withdraw
hoses at same time.
