RUGGEDCOM WIN5237
Installation Guide
Chapter 2
Installing the Subscriber Station
Mounting the Subscriber Station to a Wall or Tower
11
Section 2.6.1
Mounting the Subscriber Station to a Wall or Tower
Mount the subscriber station to any wall or tower capable of supporting its weight. An outer wall on a roof or
other high location to avoid interference from other buildings or trees is preferred.
To mount the subscriber station to a wall or tower, do the following:
1. Attach the subscriber station to the mounting bracket.
6
5
7
1
3
5
6
4
8
2
9
10
2
Figure 3: Mounting the Subscriber Station to a Wall or Tower
1.
Subscriber Station
2.
Mounting Kit
3.
Wall Holder/Pole Mount
4.
M8 × 25 mm Hex Screw
5.
M8 Spring Washer
6.
M8 Flat
Washer
7.
M8 Nut
8.
M5 Flat Washer
9.
NS 1/4" × 1/2" HEX Chipboard Screw
10.
Wall Anchor
2. Liberally apply an anti-corrosion spray to all galvanized steel components, including mounting brackets,
washers and screws.
3. Select a mounting location on the wall.
4. Place the mounting bracket on the wall and mark four mounting holes.
5. Drill four holes and insert a wall anchor into each hole.
6. Secure the mounting bracket to the wall with four 1/4" × 1/2" HEX screws, four spring washers, and four flat
washers.
7. Connect the arm bracket to the mounting bracket using a screw, spring washer, flat washer and nut. Make
sure the nut is hand tight
