Installing the Device
2
This chapter describes how to install the device, including mounting the device, con-
necting power, and connecting the device to the network.
DANGER
Electrocution hazard – risk of serious personal injury and/or damage to equipment.
Before performing any maintenance tasks, make sure all power to the device has
been disconnected and wait approximately two minutes for any remaining energy
to dissipate.
WARNING
Radiation hazard – risk of serious personal injury. This product contains a laser sys-
tem and is classified as a
CLASS 1 LASER PRODUCT
. Use of controls or adjustments
or performance of procedures other than those specified herein may result in haz-
ardous radiation exposure.
WARNING
Radiation hazard – risk of Radio Frequency (RF) exposure. This device is compliant
with the requirements set forth in FCC 47 CFR, section 1.1307, addressing Radio Fre-
quency (RF) exposure from radio frequency base stations, as defined in FCC OET Bul-
letin 65 [http://transition.fcc.gov/Bureaus/Engineering_Technology/Documents/bul-
letins/oet65/oet65.pdf]. The emitted radiation should be as little as possible. To
achieve minimum RF exposure, install the device when it is configured not to trans-
mit and set it to operational mode remotely, rather than having a technician enable
transmission on-site. For maintenance of the base station, or other operations which
require RF exposure, the exposure should be minimized in time and according to the
regulations set forth by the country of installation or the Federal Communications
Commission (FCC).
NOTICE
This product contains no user-serviceable parts. Attempted service by unauthorized
personnel shall render all warranties null and void.
Changes or modifications not expressly approved by Siemens AG could invalidate
specifications, test results, and agency approvals, and void the user's authority to
operate the equipment.
NOTICE
This product should be installed in a
restricted access location
where access can only
be gained by authorized personnel who have been informed of the restrictions and
any precautions that must be taken. Access must only be possible through the use of
RUGGEDCOM RX1512
Installation Manual, 07/2019, C79000-G8976-1057
5
