RUGGEDCOM ROX II
User Guide
Chapter 3
Device Management
Managing Serial Port Protocols
119
1. Navigate to
interfaces
»
serial
»
port
»
{slot/port}
, where
{slot/port}
is the slot name and port number of the
serial port.
2. Click
reset
in the menu. The
Trigger Action
form appears.
1
Figure 121: Trigger Action Form
1.
Perform Button
3. Click
Perform
.
Section 3.21
Managing Serial Port Protocols
The following sections describe how to configure and manage serial port protocols:
•
Section 3.21.1, “Raw Socket Concepts”
•
Section 3.21.2, “Modbus TCP Concepts”
•
Section 3.21.3, “DNP Concepts”
•
Section 3.21.4, “Viewing a List of Serial Port Protocols”
•
Section 3.21.5, “Adding a Serial Port Protocol”
•
Section 3.21.6, “Configuring the DNP Protocol”
•
Section 3.21.7, “Configuring the Modbus TCP Protocol”
•
Section 3.21.8, “Configuring the Raw Socket Protocol”
•
Section 3.21.9, “Deleting a Serial Port Protocol”
•
Section 3.21.10, “Managing Device Address Tables”
•
Section 3.21.11, “Managing Remote Hosts”
Section 3.21.1
Raw Socket Concepts
The raw socket protocol transports streams of characters from one serial port on the device to a specified remote
IP address and port. The raw socket protocol supports TCP and UDP transport.
Summary of Contents for RUGGEDCOM RX1510
Page 32: ...RUGGEDCOM ROX II User Guide Preface Customer Support xxxii ...
Page 44: ...RUGGEDCOM ROX II User Guide Chapter 1 Introduction User Permissions 12 ...
Page 62: ...RUGGEDCOM ROX II User Guide Chapter 2 Using ROX II Using the Command Line Interface 30 ...
Page 268: ...RUGGEDCOM ROX II User Guide Chapter 4 System Administration Deleting a Scheduled Job 236 ...
