Siemens RUGGEDCOM RX1510, User Manual, Page: 160 / 856

Chapter 3
Device Management
RUGGEDCOM ROX II
User Guide
128 Deleting a Serial Port Protocol
Parameter Description
pack-char Synopsis: off,
Default: off
The numeric value of the ASCII character which will force forwarding of
accumulated data to the network.
pack-timer Default: 1000
The delay from the last received character until when data is forwarded.
pack-size Synopsis: max,
Default: max
The maximum number of bytes received from the serial port to be forwarded.
turnaround
Default:
0
The amount of delay (if any) to insert between the transmissions of individual messages
out the serial port.
call-direction
Synopsis:
in, out, both
Default: out
Whether to accept an incoming connection, place an outgoing connection or do both.
max-connection
Default:
1
The maximum number of incoming connections to permit when the call direction is
incoming.
remote-ip The IP address used when placing an outgoing connection.
remote-port The TCP destination port used in outgoing connections.
local-ip The IP address used to establish a connection. Leaving it blank allows an incoming
connection to any interface.
local-port The local TCP port to use to accept incoming connections.
transport Synopsis: tcp, udp
Default: tcp
The transport connection protocol (UDP or TCP).
5. If the transport connection protocol is set to UDP, configure one or more remote hosts for the port. For more
information about adding a remote host, refer to Section 3.21.11.2, “Adding a Remote Host” .
6. Click
Commit
to save the changes or click
Revert All
to abort. A confirmation dialog box appears. Click
OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 3.21.9
Deleting a Serial Port Protocol
To delete a serial port protocol, do the following:
1. Change the mode to
Edit Private or Edit Exclusive .
2. Navigate to interface » serial » {slot/port} » protocols , where {slot/port} is the slot name and port number
of the serial port. The Serial Protocols table appears.