Siemens RUGGEDCOM RSL910, Installation Manual

Page: 19 / 48

RUGGEDCOM RSL910
Installation Guide
Chapter 2
Installing the Device
Mounting the Device on a DIN Rail 9
NOTE
For detailed dimensions of the device with either DIN rail or panel hardware installed, refer to
Section 5.6, “Dimension Drawings” .
CONTENTS
• Section 2.3.1, “Mounting the Device on a DIN Rail”
• Section 2.3.2, “Mounting the Device to a Panel”
Section 2.3.1
Mounting the Device on a DIN Rail
For DIN rail installations, the RSL910 can be equipped with a DIN rail bracket pre-installed on the back of the
chassis. The bracket allows the device to be slid or clipped onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1. Align the slot in the bracket with the DIN rail.
1
1
2
Figure 2: DIN Rail Mounting
1. DIN Rail 2. DIN Rail Bracket
2. Pull the release on the bracket down and slide the device onto the DIN rail. Let go of the release to lock the
device in position. If access to the release is limited, use a slotted screwdriver or a similar tool to reach the
release.