Siemens MJ-4A, Installation Manual

Page: 16 / 41

12
•
xxx3 , xxx4 , or xxx5 indicate a communication problem. Contact Siemens for assistance.
7 Cabling the Communications Module to the Power System
Connect the communications modules using the recommended cable as described in sections 7.1 to 7.3 below. The
following sections provide some general guidelines for cable selection and explain the different cable parameters.
Make connections between the device and the communications unit with the appropriate connector.
Typically, RS-485 requires custom wiring to the other devices. Consult the device’s pin assignments to determine
the applicable connections. Typically, a DB-9 or DB-25 will be needed for making RS-232 connections to the RTU,
personal computer, or other device. Use the supplied Phoenix Contact Screw Terminal Block (MSTBT 2, 5/8-ST-5,
08) for connections to the RS-232/485 interface. Use an ST optical connector when making connections to the fiber
optic interface.
Though the cabling for the Fiber Optic and the RS-232-/485 interfaces may be done and either interface may be
made available for communication, only one of the interfaces may be used at a time.
7.1 Fiber Optic Cable Type
The recommended cable is 62.5/125
µ
m diameter fiber optic cable with a maximum attenuation of 5dB/km at a
wavelength of 820-850 nm. If this is not available use 50/125
µ
m diameter glass cable, but only for cable lengths
less than 1500 feet. Use of 50/125
µ
m diameter cable requires that the range jumper J12 be set for long range. This
will provide protection against under driving the receiver. When using 50/125
µ
m cable, install the long range
jumper (J12) even for very short cable lengths.
A 100/140
µ
m diameter cable can also be used for cable lengths less than 1500 feet. Use of this cable requires that
the range jumper J12 be set to normal. This setting will provide protection against overdriving the receiver.
Plastic cable is not recommended due to the coupling efficiency of the cable, which at short lengths will overload
the optical receiver. In addition, the large cable attenuation normally associated with plastic cable limits the useful
link lengths to a fraction of that achievable with glass cable.
7.1.1 Fiber Optic Cable Lengths
Calculate cable length by determining the output power of the transmitter (P
TX
) and the input receive level (Peak
Input Power Logic Level Low Receiver Sensitivity, P
RX
). The difference between the two numbers is the optical
power budget (P
B
’).
P
B
’ = P
TX
– P
RX
For example, if transmitter output power is -16 dBm and the input receive level is -24 dBm, the optical power
budget is then 8 dBm. Subtract from this value the fixed losses (i.e. connector losses, splice losses, P
Loss
) to obtain
the real power budget (P
B
).
P
B
= P
B
’ – P
Loss
Divide the result by the cable attenuation (Att) in dB/km to arrive at the maximum cable length. Note that the
transmitter output power data given in the specifications already includes connector loss when using precision
ceramic ST connectors.
Length = P
B
/ Att
7.1.2 Fiber Optic Connector
The fiber optic cables (or “patch cords”) used with the MJ-4 Fiber Optic Communications Module must be
terminated with ST style connectors and have a numerical aperture of 0.275 ± 0.015.
(If pre-terminated cables are not used, follow the instructions supplied by the manufacturer to attach the connector
to the fiber cable using the cable type recommended in section 7.1.)