Siemens Industry, Inc.
Building Technologies Division
P/N 315-034090-11
3
When selecting the location to mount the LVM, keep in mind that no modules or
power supplies/extenders can be installed in the space on the CAB-MP or
REMBOX-MP directly behind the LVM.
When using a REMBOX 2/4, the OCM-16 and SIM-16 cannot be used.
INNER DOOR
PMI/PMI-2
LVM
Figure 4
Mounting the LVM To The Rear Of The Inner Door
CAN cable CCL, a 30 inch long 6 wire cable, P/N 599-634214, connects the LVM to
the next CAN module or P3 on the CC-5/CC-2 or P4 on the RNI.
A 24 inch long 10 wire audio cable, P/N 555-134260, connects the LVM to P4 on the
CC-5/CC-2, or JP6 on the PMI, or J1 on the PMI-2 or P1 on the RNI. (Refer to Figure 5.)
Make sure that all cables seat fully into their connectors. Secure the cable in the back
box using cable ties and the tie down points in the enclosure. The cable must have
sufficient slack to allow the inner door to open fully without putting stress on the
cable.
WIRING
Remove all system power before installation, first battery then AC. (To power up,
connect the AC first, then the battery.)
•
Each LVM module is a node in the CAN bus.
•
Each LVM connects either through the CC-5/CC-2 CAN bus via a plug-in
cable to the DAC or via the RNI.
•
Up to 99 CAN modules, in any combination, can be connected to the CAN
bus of each DAC.
•
Each LVM module is shipped with one CCL cable.
