18
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
1.
Detach the oven door and lay it on a cloth with the handle
facing down.
2.
Pull off the cover at the top of the oven door. Press in the
tabs on the left and right using your fingers (fig. A).
3.
Lift the top panel up and pull it out (fig. B).
4.
Lift the panel up and pull it out (fig. C).
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left.
1.
Insert the panel at an angle towards the back (fig. A).
2.
Insert the top panel at an angle towards the back into the
brackets. The smooth surface must face outwards. (fig. B).
3.
Put the cover back in place and press on it.
4.
Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Fault table
If a dish does not turn out as well as you had hoped, refer to
the chapter:
Tested for you in our cooking studio.
It contains
useful tips and information on cooking, baking and roasting.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
%
$
&
%
$
Fault
Possible cause Troubleshooting/informa-
tion
The oven does
not work.
Faulty circuit
breaker
Look in the fuse box and
check that the circuit
breaker is in working order.
Power cut.
Check whether the kitchen
light or other kitchen appli-
ances are working.
flashes in the
clock display.
Power cut.
Reset the clock.
Oven not hot.
Dust on the
contacts.
Turn the control knobs
clockwise and anti-clock-
wise a few times.
The burner
does not ignite.
Power cut or
damp ignition
plugs.
Light the gas burner with a
gas lighter or a match.
The gas grill
does not work.
The protecting
plate is incor-
rectly inserted.
Make sure that the protect-
ing plate is correctly
inserted.
Remove the protecting
plate and reinsert it.
Fault
Possible cause Troubleshooting/informa-
tion
