Siemens HB84K.52B, Instruction Manual, Page: 14 / 32

14
Malfunction table
Error messages
If an error message with
“
appears, press the
0
button. Then
reset the clock. If the error message appears again, call the
after-sales service.
You can take remedial action yourself for some error
messages.
Replacing the oven light bulb
It is possible to replace the oven light. Heat-resistant 12 V,
20 W halogen bulbs can be obtained from After-sales Service
or a specialist retailer.
ã=
Risk of electric shock!
Never replace the oven light when the appliance is switched on.
Pull out the mains plug or switch off the appliance at the circuit
breaker in the fuse box.
Note:
Always remove the new halogen bulb from the packaging
using a dry cloth. This increases the service life of the bulb.
Method
1.
Switch off the circuit breaker in the fuse box.
2.
Place a tea towel in the cold oven to prevent damage.
3.
Remove the glass cover. To do so, prise open the glass
cover at the bottom by hand.
Should you experience difficulties removing the glass cover,
use a spoon to help. (Fig. A)
4.
Remove the bulb and replace with a bulb of the same type.
(Fig. B)
Problem Possible cause Remedy/information
The appliance does not work Defective fuse Look in the fuse box to make sure that the
fuse for the appliance is OK.
Plug not plugged in Plug it in.
Power cut Check whether the kitchen light works.
0
and three zeros light up in the
display.
Power cut Reset the clock.
The oven does not heat up. The
colon in the display flashes.
The oven is in demonstration mode. Switch off the circuit breaker in the fuse box
and switch it on again after approx. 20
seconds. Then, within approx. 2 minutes,
press and hold the
@ button for approx. 4
seconds until the colon remains
continuously on.
F8 appears in the display. Automatic switch-off has been activated. Turn the function selector to the zero
position.
The microwave does not switch on. Door not fully closed. Check whether food remains or foreign
material is trapped in the door. Make sure
that the sealing surfaces are clean. Check
whether the door seal is twisted.
The microwave was not started.
Press the
†
button.
The appliance does not heat up to
the temperature which has been set.
The
†
button was not pressed. Press the
†
button.
Microwave operation has been
cancelled for no apparent reason.
The microwave has a fault. If this fault occurs repeatedly, please call the
after-sales service. Oven operation without
microwave is possible.
With microwave operation, the food
takes longer to heat up than before.
The microwave power setting is too low. Select a higher power setting.
A larger amount than usual has been placed
in the appliance.
Double the amount = almost double the time
The food was colder than usual. Stir or turn the food during cooking
Error message Possible cause Remedy/Note
The error message “E101” or “E104”
appears on the clock display.
The temperature sensor has failed. Call the after ­ sales service. Microwave
operation is possible on its own.
The error message “E010”, “E310”,
“E009” or “E309” appears on the
clock display.
Technical malfunction. Call the after ­ sales service.
$
%