Siemens ET6 FFP Series, User Manual

Page: 13 / 16

Disposal
en
13
▶
Call the customer service.
14.1 Information on display panel
Fault Cause and troubleshooting
None There has been a power cut.
1.
Check the household fuse for the appliance.
2. Check whether there has been a power failure by trying other electrical appli-
ances.
All displays flash The control panel is wet or objects are lying on it.
▶
Dry the control panel or remove the object.
Several hotplates have been used over a prolonged period at high power set-
tings. The hotplate has been switched off to protect the electronics.
1.
Wait a while.
2. Touch any touch field.
a
When the message no longer appears, the electronics have cooled down
sufficiently. You can continue to cook.
Despite being switched off by , the electronics have become hot again. All
hotplates have therefore been switched off.
1. Wait a while.
2.
Touch any touch field.
a When the message no longer appears, the electronics have cooled down
sufficiently. You can continue to cook.
and the heat setting flash al-
ternately. A signal sounds.
Hot pot near the control panel. There is a risk that the electronics will overheat.
▶
Remove the pan.
a
The display goes out shortly afterwards.
and audible signal Hot pot near the control panel. The hotplate has been switched off to protect the
electronics.
1. Remove the pot.
2.
Wait a while.
3. Touch any touch field.
a
When the message no longer appears, the electronics have cooled down
sufficiently. You can continue to cook.
The hotplate was on for too long and has switched off automatically.
You can switch the hotplate back on again immediately.
and hotplates do not heat up Demo mode is activated.
1.
Disconnect the appliance from the power supply for 30 seconds by briefly
switching off the circuit breaker in the fuse box.
2.
Touch any touch field within the next three minutes.
A message with "E" appears on
the display, e.g. E0111. The electronics have detected a fault.
1. Switch the appliance off and on again.
a
If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the
exact error message when calling.
→
"Customer Service", Page 14
15 Disposal
Find out here how to dispose of old appliances cor-
rectly.
15.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
▶
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.