40
To put the
shutter control timer ‘Komfort’ into
operation, enter the actual data as follows
(date/hour):
1. Keep the
Set
key depressed until prog appears
on the display.
2. The keys
or
are used to select the
following settings (see diagram):
Hour/date
l
: setting of actual data
: programming of memory A
: programming of memory B
: programming of memory C
: storing of shutter run times
Astro
l
: setting of shifts Astro time shifts
: setting of sunset/twilight
brightness
Info: If no key is pressed for more than 2 minutes in the programming mode, the timer
quits this mode and switches over automatically to displaying the actual time.
Inputs not confirmed with the
Set
key by this time will be disregarded.
The programming mode can be interrupted at any time by prerssing
Set
for more
than 3 seconds.
3. Select the date/hour symbol with the
or
keys
4. Confirm the selection of the date/hour function
by pressing
Set
briefly
The timer attachment is now in the actual data
set mode
Time
Setting the current data
Programming memory A
Programming memory B
Programming memory C
Learning louver running time
Shifting astro times
Setting the sun / twilight value
GB
4.3. Setting the actual data
Setting the actual data
Summary of Contents for DELTA i-system
