Product overview
2.4 Communications processor CP 1625Dev
CP 1625 / CP 1625Dev
Operating Instructions, 04/2018, A5E43075902-AA
17
Interface/jumper X2000
At interface X2000 you use the jumper to set whether the CP 1625Dev should be operated in
an IPC or externally in Development mode.
The interface is designated with the number
⑦
in the figure above.
Figure 2-6
X2000
Pin assignment
Description
Pins 1 and 2
Power supply via PCIe bus
Pins 2 and 3
Power supply over X80 (with external use of the CP 1625Dev)
NOTICE
Damage to the IPC or the CP 1625Dev
Damage can occur if the jumper is inserted incorrectly on the X2000 interface and the IPC
is then connected to a 24 V DC power supply.
Set the position of the jumper on the X2000 interface according to the use of the CP 1625.
Interface/jumper X2200
At interface X2200 you use the jumper to set whether the SOC1 is to boot from NAND flash.
The interface is designated with the number
⑤
in the figure above.
Figure 2-7
X2200
Pin assignment
Description
Pins 1 and 2
Boot from SPI flash (with use of the PCIe bus)
Pins 2 and 3
Boot from NAND flash (with external use of the CP 1625Dev)
Siemens Automation Parts
