Installation
9
Siemens Building Technologies
Fire Safety & Security Products
02.2010
2.2
Mounting with the distance frame
2.2.1
Wall-mounting with distance frame
1.
The unit should be installed on as even a surface as possible.
2.
Create openings for the lead in the distance frame and pull the lead through.
3.
Screw the distance frame onto the base/ wall.
2.2.2
Installation
1.
Remove the top section of the housing from the bottom section.
2.
Connect the cable to the terminal strip of the reader (top section of housing).
See chapter „3.1 Connecting the reader“
Do not mount the unit to the wall before you have checked the set-up works
correctly.
3.
Screw the bottom section of the housing, onto the flash mounting box. Using
the 3 x 16 mm self-tapping screws.
4.
Plug the top section of the housing onto the bottom section of the housing.
5.
Screw in the safety screw on the underneath of the bottom section of the
housing.
2.3
Opening the housing
If you attach the top section of the housing to the bottom section, it slots into place.
This means you should proceed as follows when opening the housing:
1.
Undo the safety screw (1)
2.
Insert a screwdriver into the two points on the side of the reader housing be-
tween the top and bottom sections of the housing (2).
3.
Remove the top section of the housing from the bottom section.
Fig. 3
Opening the housing
