Siemens 7KG6000-8AA, Operating Instructions Manual

Page: 26 / 84

26 SIMEAS E50417-K109U-C322-A1
Terminals
Jumper positions:
Jumper positions:
load-independent current load-independent voltage
To change the jumper positions, the following instructions must
be observed:
•
Short circuit the ct’s if required.
•
To remove lid from case insert a flat screwdriver approx.
0.8 * 3.5 mm with an angle of 45° into one after another of the
locking hooks and twist the screwdriver by approx. 45°.
Make a note of the location if necessary.
•
Pull the modules half-way out by slightly moving them back and
forth.
•
Change the jumper positions as required.
•
Plug the modules back into the device
(position the power supply in the middle slot).
•
Snap the cover back into its correct position.
Output 3
Output 3
Output 1
Output 2
Output 2
Output 1