Siemens 7KG6000-8AA, Operating Instructions Manual

Page: 25 / 84

E50417-K109U-C322-A
1
SIMEAS 25
•
Before inital energization with the supply voltage, the device
shall be situated in the operating area for at least two hours in
order to ensure temperature equalization and to avoid
humidity and condensation.
1.13 Changing the analog output signal
For the analog output signals, either current or voltage can be
selected. In the default mode, all outputs are set to load-
independent current supply.
In order to change the analog outputs to voltage, the
corresponding jumpers on the board must be positioned according
to the sketch below (jumper X100 refers to output 1, jumper X200
refers to output 2 and jumper 3 refers to output 3).
WARNING!
When carrying out changes on site, the instructions for handling
electrostatic sensitive devices and components must be observed (ESD).