6
AEROMAT VT WRG 1000
Assembly Instructions
Last update: 10.2014
Installation sequence
1. Remove the AEROMAT VT WRG 1000 carefully from the packaging and do not place it on the weather grille or front
panel. We recommend storing the unit on a soft surface (e.g. cardboard or sheet) during installation.
2. Close the locking bolts on the front to prevent contamination (e.g. dust) from entering the unit during installation. If the
AEROMAT VT WRG 1000 does not have locking bolts, tape up the recesses in the front panel with film.
3. Make sure that no debris or liquids get into the AEROMAT VT WRG 1000 or its included weather grille until it has been
installed into the exterior insulation and cladding.
Attention!
Depending on the installation location of the AEROMAT VT WRG 1000 it may be necessary to mask up (with
adhesive tape) areas which may be exposed to rainfall.
Example
„Installation concealed in the wall with wall duct“
Example
„Installation concealed in the lintel“
foil
adhesive tape
AEROMAT VT
exterior insulation
adhesive tape
AEROMAT VT
adhesive tape
foil
adhesive tape
exterior insulation
4. Install the AEROMAT VT WRG 1000 in its intended installation position and seal it in accordance with the installation
directives applicable on site.
5. Check that the AEROMAT VT WRG 1000 is clean prior to installation. If necessary, clean the unit thoroughly as descri-
bed in our operating and care instructions.
Attention!
Only drill in through-holes for window plugs and screws in the area indicated (see marker tape).
Important!
Remove any marker tape that is visible after installation.
Summary of Contents for AERO AEROMAT VT WRG 1000
Page 11: ......
