3 YEARS
LIMITED WARRANTY
9
Operation
WARNING: check that the main voltage is correct! The power supply voltage must match the
voltage specified on the machine nameplate.
Turn on, turn off
to. Connect the plug to the power source, the power light will illuminate until it is disconnec-
ted from the mains.
b. Turn the tool on or off by squeezing or releasing the switch trigger.
c. For continuous operation, simply press the lock button on the left side of the handle.
Cutting methods
Parallel cut adjustment
a. Loosen the edge guide locking knob.
b. Slide the edge guide through the grooves in the shoe to the desired width.
c. Tighten the locking bolt to secure it in position.
d. Make sure that the edge guide rests again on the wood along its entire length for even para-
llel cuts.
Install the ripp guide (see fig. 2)
a. Install the cutting guide on the machine, perform
the following steps.
to. Unplug your circular saw.
b. Insert the cutting guide through all the grooves
on the motherboard at the front of the base.
c. Slide the left guide through the slots until it
extends down the right side of the motherboard.
d. Adjust the cutting guide to the desired cutting
width, and then tighten the cutting guide locking
screw securely.
Summary of Contents for HM718
Page 32: ......
