SIEB & MEYER Drive System SD3 Series, Hardware Description

Page: 45 / 85

Fig. 9: Slot of the microSD card
The figure shows how to insert a micorSD card correctly into the card
reader of the device.
The card reader comes with push-push mechanism: Push the card into the reader until
it locks right behind the front panel; push on the locked card to eject it again.
8.3 X14 – Ethernet
The interface is only suitable for control purposes in the industrial environment. It must
not be connected to IT networks according to DIN EN 60950.
Data transfer rate: 10 Mbit, 100 Mbit, 1 Gbit
Make sure that you use a suitable patch cable for Ethernet or a correspon‐
ding Ethernet switch:
▶ 100-Mbit transmission: communication via 4 wires
▶ 1-Gbit transmission: communication via 8 wires
8-pole female RJ45 connector
X14 Pin I/O Name Description
1 O MDI0+ Transmit data +
2 O MDI0− Transmit data −
3 I MDI1+ Receive data +
4 O MDI2+ Transmit data +
5 O MDI2− Transmit data −
6 I MDI1− Receive data −
7 I MDI3+ Receive data +
8 I MDI3− Receive data −
Related topics
LED description: "LED Status Display of the Ethernet Interface", page 67
W
Connector Pin Assignment
Drive System SD3 - Hardware Description 45
8