6
Software and Driver Installation
Before installation you must deactivate the virus scanner temporarily.
To operate the of the CNC modules 0460123A, 0480123A and 0480123D you must
install software and a driver:
▶
PC software with USB driver
▶
machine software
The USB drivers are automatically installed with the PC software, when prop‐
erly installed.
Supported Operating Systems
The CNC modules 0460123A, 048012348.00 A (CNC 48.00 compact) and
048012348.00 D (CNC 48.00 compact VS) can be operated with PCs with the
following operating systems:
▶
Windows
®
7 (only 32 bit version)
▶
Windows
®
Vista (only 32 bit version)
▶
Windows
®
XP (only 32 bits version)
▶
Windows
®
10 (only 32 bit version)
Error message in Windows 7 Ultimate
If an error appears during the installation indicating that the 16 bit-application could not
be started, the error was caused by the length of the file name.To solve the problem,
you must enable the option in the DOS of the PC allowing to use of long file names.
Take the following steps:
▶
Click on “Start
ÿ
All Programs
ÿ
Accessories
ÿ
Command Prompt”.
▶
Enter the following command line (see figure):
C:\Users\Test\AppData\Local\Temp>fsutil 8dot3name set c: 0
W
Software and Driver Installation
0460123A/0480123A/0480123D -
25
6
Summary of Contents for 0460123A
