6
Stabilizer Operation and User guide
version 2950-4 - 2018
Settings
SETTINGS screen
1.
Goes to «SYSTEM STATUS» page (D)
2.
Goes to «SYSTEM INFO» page (E)
3.
Goes to «STARTUP» page (F)
4.
Goes to «SETUP» page (G)
5.
Returns to MENU (B)
SYSTEM STATUS screen
1.
If lit – the system is getting a valid GPS signal
(if not the stabilizer will not work)
2.
Shows info about:
GPS SPEED : the actual speed input from GPS
SYSTEM STATE : the state the system is in at present
(Cruising, At Anchor, Off, Init, Suspended)
SYSTEM PRESSURE : Shows the hydraulic pressure at present
3.
Returns to SETTINGS menu (C)
SYSTEM INFO screen
1.
ECU = Main controller serial number
2.
ECU = Main controller software version
(programmable by S-link)
3.
ECU = Main controller Hardware version
4.
ECU = Main controller bootloader version
(may need update through S-link to support
further updates later)
5.
Control panel software version.
Seperate update directly in panel – not by S-link
6.
Shows the total operating hours of the system
7.
Shows the operating hours of the system since main authorized service.
See seperate section in manual for service intervals
8.
Press to program date and time
9.
Returns to SETTINGS menu (C)
SET DATE/TIME screen
Shows current date/time.
Touch date/time numbers to change.
Goes back to
«SETTINGS» menu
(click with mouse to
go there)
Press to program date
and time
ECU = Main controller
serial number
ECU = Main controller
software version
(programmable by S-
link)
ECU = Main controller
bootloader version
(may need update
through S-link to
support further
updates later)
ECU = Main controller
Hardware version
Control panel software version.
Seperate update directly in
panel – not by S-lilnk
Shows the total
operating hours of
the system
Shows the operating
hours of the system
since main
authorized service
See manual for
service intervals
1
2
3
4
5
1
2
3
4
5
8
6
7
9
PANEL
1
2
3