7
SE 40/125S ignition protected thruster assembly
version 1.3 - April 2014
1. Push the propeller on to the shaft and turn until the internal spline in the propeller hub aligns with the external spline on the
propeller shaft.
2. Push the propeller onto the shaft with the track for the drivepin in an horizontal position (same direction as you set the drivepin), all
the way in. There should be almost no gap between the propeller hub and the gearhouse.
3. Place the washer (4) on the propeller shaft and then tighten the lock-nut (3) on the propeller shaft.
4. Place the anode (2) in its designated position and tighten the anode holding screw (1). Apply a thread glue (Loctite or similar) to
ensure that the anode holding screw does not un-screw itself from the propellers rotation.
Parts description:
1 : Screw for anode
2 : Anode
3 : Propeller lock nut
4 : Washer
Fitting propellers
Fig. 1
1
Thread
glue
2
3
4
