Sicma S.p.A.
Miglianico (CH)
page 19
BELT TENSION CHECK
Belts have an automatic spring tensioner and need a check on the condition of springs.
To increase or decrease tension of belts proceed as follows:
•
Stop the machine.
•
Disassemble the PTO shaft or
remove ignition key.
•
Take off screws of the two
transmission covers, upper and
lower.
•
Remove the two covers.
•
Act on the nuts (A) of rod (B) which
is threaded to stretch or extend the
spring (C) with a power of 9 kg (20
lb).
•
If the spring is slackened it is
necessary to replace it; first it is
necessary to disassemble the
threaded rod.
•
Block the rod washers.
•
Reassemble the two transmission
covers and tighten the relevant
screws.
SPARE PARTS ORDERING
To order spare parts, please consult relevant catalogue.
Request of spare parts must be made to the retailer or to the nearest service centre and must
always be complete with the following information:
-
Type and width of the equipment.
-
Part number of the needed spare part. If not in possession of this number, you can replace it
with the number of the table where the part is represented and the correspondent reference.
-
Denomination of the needed part and desired quantity.
-
Preferred transportation mode. When this preference is not specified, the retailer or service
centre, even if paying great care to this type of service, do not answer for possible shipping
delays due to force majeure. Transport charges must always be paid by the addressee.
