18
8025999/V1-0/2021-02 | SICK
OP E R A T I N G I N S T R U C T I O N S | MICS3/OS3 electr. protection hood
Subject to change without notice
4
INSTALLATION
Observe scan plane, see also dimensional drawing
.
4.3
Installation process
Provide tools for the screw type used.
▸
Loosed knurled screws on the protection hood and remove hood.
▸
Mount protection hood mechanism to the support unit (M8 screws).
▸
Check the mobility of the protection hood mechanism by hand (up and down move
-
ment).
▸
Mount safety laser scanner to mounting kit 1a.
Observe the installation instructions in the corresponding SICK operating instructions.
▸
Seal unused connections with sealing caps.
▸
Connect the cables to the safety laser scanner. Observe cable routing.
▸
For tightening torque of plug connector and protective caps, see the laser scanner oper
-
ating instructions.
Fig. 11: Safety laser scanner connecting cables and cable routing to the rear
CAUTION
Hazard due to hand injuries caused by crushing
▸
During the entire installation phase, the MICS3/OS3 electr. protection hood is
not connected to the control and is de-energized.
Note
Installation sequence:
▸
Mount the protection hood without safety laser scanner to the support unit.
▸
Mount safety laser scanner to the protection hood.
CAUTION
Hazard due to hand injuries caused by crushing
▸
Wear safety gloves.
Legend
1
Voltage supply XD1
2
Cable tie for fixing cables
3
Ethernet XF1
4
Ethernet XF2
