Perform all connection work only at ambient temperatures above 0 °C.
Wire cross-sections in the supply cable from the customer’s power system must be
implemented in accordance with the applicable standards.
In the case of open end cables, make sure that bare wire ends do not touch. Wires
must be appropriately insulated from each other.
Wire cross-sections of the data and switching signal cables have to also be designed in
accordance with the applicable national standards.
6.2.1
Data cables
NOTE
Layout of data cables
■
Use screened data cables with twisted-pair wires.
■
Implement the screening design correctly and completely.
■
To avoid interference, always use EMC-compliant cables and layouts. This applies,
for example, to cables for switched-mode power supplies, motors, clocked drives,
and contactors.
■
Do not lay cables over long distances in parallel with power supply cables and
motor cables in cable channels.
•
The possible length of cable between the device and host computer depends on
the following factors:
°
The physical version of the host interface selected
°
The data transmission rate set in the device
For further information,
see "Wiring the CAN interface", page 28
6.3
Pin assignments of electrical connections
Connection mask (variant A, variant B)
The device is equipped with either the variant A connection mask or variant B connec‐
tion mask. Different electrical connections are available depending on the connection
mask. For each electrical connection described below, the available connection masks
for that connection have been indicated. The variant A can only be operated with a
Sensor Integration Machine (SIM). The variant B can be operated with both a SIM and a
CDF600 fieldbus module.
Figure 7: Variant A connection mask
Figure 8: Variant B connection mask
ELECTRICAL INSTALLATION
6
8023775/1A4I/2020-12-01 | SICK
T E C H N I C A L I N F O R M A T I O N | Camera ICD880/890 Generation 4
23
Subject to change without notice
