5.4
Mounting the protective double bushing on the protective housing
During assembly, the connection cables are routed through the supplied protective
double bushing and connected to the device in the protective housing.
When the Ethernet interface is not being used, seal off the free pass-through of the
protective double bushing with the supplied protective element.
NOTE
Use connection cables with a sufficient length.
NOTICE
Equipment damage or unpredictable operation due to working with live parts.
Working with live parts may result in unpredictable operation.
■
Only carry out wiring work when the power is off.
■
Only connect and disconnect electrical connections when the power is off.
NOTICE
Do not damage the O-rings by using sharp or pointed tools. The O-rings seal the
protective double bushing towards the outside and therefore guarantee the enclosure
rating.
5.4.1
Assembly with use of the Ethernet connection
Noting the MAC address
NOTE
The MAC address for the Ethernet interface is located on the type label. The address is
partially or completely covered when the device is mounted on a bracket.
b
Note the MAC address together with the name of the reading station,
Mounting the protective double bushing on the protective housing
The assembly procedure is described for the protective housing with front viewing
window. The protective housing for fixed mount bar code scanners with oscillating
mirror and side viewing window is assembled analogously.
Component overview
1
2
3
4
5
6
7
8
9
ß
Figure 12: Assembly of IP69K protective housing, with use of the Ethernet connection
1
Connection cable for “Ethernet” connection
MOUNTING
5
8021479/19ZB/2021-10-29 | SICK
T E C H N I C A L I N F O R M A T I O N | CLV62x, CLV63x and CLV64x with IP69K Protective Housing
23
Subject to change without notice
