Operating Instructions
Chapter
4
C 4000
28
©
SICK AG • Safety Systems • Germany • All rights reserved
8 009 221/16-11-00
Installation and mounting
4.2.2
Mounting with side bracket
The side bracket is made of die cast zinc ZP 0400. It is enamelled in black. The side bracket
is largely covered by the device. But it is only suitable for mounting surfaces lying parallel
to the desired protective field because the alignment of sender and receiver can only be
adjusted by a maximum of
±
2.5° after mounting.
Fig. 21: Composition of the
side bracket
Notes
>
Attach the bolts of the side bracket with a torque of between 5 and 6 Nm. Higher torques
can damage the bracket; lower torques provide inadequate protection against shifting.
>
When mounting the bracket, note the distance and the position of the sliding nuts as de-
scribed in chapter 10.4 “Dimensional drawings” on page 48.
Part No. 2 019 506