5.5.4
Error code
The error code is only relevant if the relevant telegram is sent by the encoder (message
ID is 0). The error code signals the success of the write command within the response
message. The remote CA receives a response to a write command and also to a
read command. If the value within the error code segment is not zero, the previous
command was not executed successfully.
Table 9: Error code
Value (hex)
Meaning
00
Successful
01
Parameter not available
02
Parameter length incorrect
03
Parameter value too high/low
04
Parameter value not supported
05
An attempt was made to read a "write-only" parameter
06
An attempt was made to write a "read-only" parameter
07
Message ID is not supported
FF
Unknown error
5.5.5
Parameter value
The parameter value contains the parameter user data. The data appears left-aligned and little endian.
The encoder is configured via the Configuration PGN EF00. The following parameters can be read and/or written
via this.
SAE J1939 INTERFACE
5
8027379/2022-01-21 | SICK
O P E R A T I N G I N S T R U C T I O N S | AHS/AHM36 SAE J1939
AHS/AHM36 SAE J1939 Inox
19
Subject to change without notice