SICK 2113101, Operating Instructions Manual

Page: 20 / 48

• Health
When Health is configured on the application diagnostic output, the application
diagnostic output signals when the protective device is only partially operational,
for example if the sender or receiver is contaminated or poorly aligned, or the
cable is damaged.
In the good state: HIGH (1), if excessively contaminated or in the event of cable
interruption LOW (0),
see table 6, page 20
Table 6: Alarm / Health
Alarm ( ≤ 100 mA) Health ( ≤ 100 mA)
+ (L+)
Alarm
‒ (M)
+ (L+)
Health
‒ (M)
+ (L+)
Alarm
‒ (M)
+ (L+)
Health
‒ (M)
4.4.5 IO-Link
Overview
The protective device is IO-Link capable.
The IO-Link communication between the protective device and a PC can occur via an
IO-Link master. To do so, connect the IO-Link master to the system connection of the
receiver, and via a USB cable to a PC.
The connected protective device can be configured, or data exchanged or transferred
using the SOPAS ET configuration software.
Important information
DANGER
The output signal of the protective device that is evaluated via the external test device
is configured via IO-Link, e.g., using the logic or time delay functions.
This can slow down the response time of the protective device, or make it not possible
to evaluate it with the external test device.
b
Use the Q configuration for the switching output when using the protective device
in conjunction with an external test device.
b
Take the use of the logic and time delay functions appropriately into consideration
in the risk assessment.
Prerequisites
• SOPAS ET configuration software
• SiLink2 Master IO-Link master
Data exchange and configuration
The following data, for example, can be exchanged or transferred via IO-Link:
• Device information
• Quality of reception
4
PROJECT PLANNING
20 O P E R A T I N G I N S T R U C T I O N S | L25 8024678/2020-01-24 | SICK
Subject to change without notice