5
INSTALLER:
• Blocking is required. The ceiling or wall used
for fixture installation must be able to support
300 lbs or more. Failure to properly secure the
screen may result in injury and/or damage.
• Electrical work should be performed using
appropriate electrical codes and regulation, by
a licensed electrical professional.
• Before running cables in walls or ceilings see
controls section on pages 19 - 21 for control
cable requirements.
• Before removing the screen from the box,
check for damage and to make sure all parts
are included.
• Do not use any sharp blades when opening the
screen packaging. Open by hand.
• Do not pull on the sides, crease, or fold the
screen. The screen material is very delicate.
• Care in mounting and correct operation will
result in long and satisfactory service from the
SI screen.
• The screen should be level when installed.
Always use a carpenter’s level.
• Nothing should be fastened to any part of the
screen assembly.
NOTE: The screen has been thoroughly inspected and
tested at factory and found to be operating properly prior
to shipment.
END USER:
• To prevent damage, the operating and
maintenance of the screen should be
performed by experienced professionals.
• This is a finished product. Do not write or draw
on the surface.
• Do not put anything near or under the screen
that would come in contact or impede
the normal operation of the screen when
deployed.
• Damage to the screen can result if an object
prevents the screen from fully deploying.
BEFORE PROCEEDING
Read the instructions in their entirety before proceeding. Actions contrary to the
instructions invalidate the warranty and may result in serious damage and/or injury.
The placement from bottom to the screen should be between 36” (91cm) - 42” (106cm).
Check the projector manual for Projector placement.
