Si-tex Explorer Nav Pro, User Manual

Page: 10 / 80

10
Chart Plotter - User Manual
3. Getting started
3.1 Switching ON
Before powering the chart plotter on, check for the correct voltage (10-35 volt) and the correct
connections with other instruments. Press and hold [POWER] to turn on the device.
It might take few minutes for chart plotter to start.
3.2 Switching OFF
Press and hold [POWER] to switch the chart plotter off. A countdown timer appears on the
screen. If you release [POWER] before the countdown timer reaches zero, the chart plotter
will remain on.
3.3 First Setup page
When turning the device on for the first time, you will see the First Setup pages. You will see
them each time after restoring to factory default settings (can be done in “General Settings” –
“Log&Backup”). This set of pages allows selecting software language, chart language, units,
time zone and time format. This information can be changed at any time in the “General
Settings” menu.
1. Switch chart plotter ON and wait for the first Setup Page to appear on the screen.
2. Select the desired option on the corresponding page by moving joystick up/down, or
keep the default value.
3. Press [ENTER] to confirm the selection.
4. Move joystick [RIGHT] to go to the next page or [LEFT] to go to the previous page.
5. On the Warning page move joystick [DOWN] to scroll the “Limitations of Use” text.
6. Press [ENTER] when you reach the end of text.
NOTE By pressing [ENTER] “OK“ you accept the “Limitations of Use”. You must accept all the
limitation specified in the Warning page in order to use the chart plotter.
3.4 Selecting the system language
To set the main language of software - menus, data pages, warning/alarm messages:
1. Open the Main Menu by pressing [MENU]
2. Select “General Settings”
3. Select “Software Language”
4. Select language by moving joystick [UP]/ [DOWN] and pressing [ENTER].