SHYAM Networks GS800 Series, Quick Start Manual, Page: 5 / 8

5
NETWORKS
GS800
2. Installing GS800
STEP 1 Place GS800 on a flat and clean surface.
STEP 2 Connect the power adaptor’s cord into the front of GS800 and then plug it into
a power source. The PWR LED should glow. In case the LED remains ‘Off’, then refer
to the “ Quick Troubleshooting ” section.
STEP 3 For each device you want to connect to GS800, insert one end of the Ethernet
cable to the port of the device and other end into the GS800 port.
i
Note : Power is supplied through an external DC power adaptor. Check the technical
specification for more details about the DC power input voltage.
Congratulations! The installation of GS800 is complete.
GS800
Computer Computer Computer Computer
DC Power Input