Seite
22
von
31
NOTE
It is recommended that the assembly be carried out by two people, in order to avoid
damaging the SHX heating panel.
1. ASSEMBLY
1. Open the gift box and take out the device.
2. Remove the packaging from the device.
3. Now check if there are any damages.
4. Carefully unwind the power cord, also paying attention to damage.
5. Place a mat on the floor (we recommend a towel) and place the panel face down
on it.
6. Now remove the protective film from the backside of the panel.
7. Measure the brackets on the back of the panel and transfer those measurments to
the wall in order to be able to drill the correct holes.
8. Now drill the holes with a hole of 10mm wide and at least 70mm deep. Make sure
the hole is vertical to the wall and pay attention to the side and vertical distance
between the holes.
9. Now insert the dowels into the holes.
10. Then screw the screws with the bracket into the
wall using a screwdriver.
11. Then hang the panel on the brackets on the
wall.
