Seite
17
von
23
START UP
The installation and operation of the SHX fan heater is very quick and uncomplicated:
1. INSTALLATION
1. Remove the fan heater from the packaging and remove all packaging materials.
2. Check the device for possible damage.
3. Unwind the power cord and also check it for damage.
4. Place the fan heater on a stable, level and heat-insensitive surface.
5. Now insert the mains plug into a suitable socket.
6. Now press the main switch 11 on the back of the device to "I" to supply the device with
power.
7. To operate the remote control, pull out the safety tab on the back of the battery
compartment.
Please follow the instructions for setting up the device from the safety instructions very
carefully.
2. FILL THE WATERTANK
1. Remove the tank from the back of the device by lifting it out.
2. Now remove the water tank and then unscrew the valve cover by turning it
counterclockwise.
3. Fill the water tank and make sure that you use clean water that is not warmer than 40
° C.
4. Do not overfill the water tank, otherwise water could get inside the device and cause
irreparable damage.
5. Screw the valve cover back onto the water tank clockwise.
6. Then put the water tank back in.
Make sure that the device is not connected to the mains when you fill the water tank.
Only fill the tank with water. You must not add any chemicals, fragrance oils, other
fragrances or other liquids to the water, as these could clog the gland and attack the
plastic!
Use only cold or lukewarm water in the water tank. The water must not be warmer than
40 ° C.
loosen
tighten
