- 41 -
POWER ON Function
This item is used to defined Keyboard & PS/2 mouse power-on function enabled or
disabled. The options are
Button Only
,
HOT-Key
and
PS/2 Mouse
.
Button Only - Only soft-on/off button on the front panel is available.
KB Power ON Password
This item set the keyboard power-on password. When using keyboard to power on ,
just Enter the password.
Hot Key Power ON
Power-on by soft-on/off button and keyboard are available. The user may set power-
on hot-key from <Ctrl><F1> to <Ctrl><F12>.
KBC input clock
This item to set the input clock to onboard keyboard controller. The options are
8MHz, 12MHz and 16MHz.
Onboard FDC Controller
This item specifies onboard floppy disk drive controller. This setting allows you to
connect your floppy disk drives to the onboard floppy connector. Choose the "
Dis-
abled
" settings if you have a separate control card.
Onboard Serial Port 1
This item is used to define onboard serial port 1 to
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4,
2E8/IRQ3, Auto
or
Disabled
.
Onboard Serial Port 2
This item is used to define onboard serial port 2 to
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4,
2E8/IRQ3, Auto
or
Disabled
.
UART Mode Select
The main board support IrDA(HPSIR) and Amplitudes Shift Keyed IR(ASKIR)
infrared through COM 2 port. This item specifies onboard Infra Red mode to
IrDA
1.0, ASKIR, MIR 0.57M, MIR 1.15M, FIR
or
Standard (Disabled).
Note : FIR is not available currently.
RxD , TxD Active
This item specifies the Active level for RxD & TxD signal.
IR Transmittion delay
This item enable/disable the delay of the IR state change from Rx to Tx mode or Tx
to Rx mode.
Onboard Parallel Port
This item specifies onboard parallel port address to
378H, 278H, 3BCH
or
Disabled.
