- 14 -
Figure 3-10 :
ATX Power Supply Connector
Figure 3-9 :
AT Power Supply Connector
Other Connectors
AT and ATX Power Supply Connectors
AT Power Connector
is a 12-pin male header
connector. Plug the connector from the power
directly onto the board connector while making
sure the pin 1 is in its position. The main board
requires a power supply with at least 200 watts
and "power good signal".
Figure 3-9 shows AT Power Supply Connector.
ATX Power Connector
is a 20-pin male header
connector is connected to the ATX power supply.
The plug of the power supply will only insert in
one orientation because of the different hole shade
and size. Find the proper orientation and push
down firmly making sure that the pins are aligned.
Figure 3-10 shows ATX Power Supply Connector.
IR Connector - J18
If you have an Infrared device, this mainboard can
implement IR (Infrared) transfer and meet both ASKIR
and HPSIR specifications. To enable the IR transfer
function, follow these steps:
Step 1.
Attach the 5-pin infrared device cable to J18
connector. (Refer to the above diagram for IR
pin assignment.)
Step 2.
Configure the Infrared transfer mode in the
UR2 Mode field of Integrated Peripherals
menu in BIOS Setup. This mainboard sup-
ports IrDA 1.0, ASKIR, MIR 0.57M and
MIR 1.15M transfer modes. FIR is not cur-
rently supported.
Figure 3-8
Figure 3-11 :
shows J18's pin assignment.
