- 28 -
F
Jumpers
Clear CMOS Setting (JP1)
JP1 is used to clear CMOS data. Clearing CMOS will result in the perma-
nently erasing previous system configuration settings and the restoring origi-
nal (factory-set) system settings.
Pin 1-2 (Default)
Pin 2-3 (Clear CMOS)
Step 1.
Turn off the system power (PC-> Off).
Step 2.
Remove ATX Power cable from ATX Power connector.
Step 3.
Remove jumper cap from JP1 pins 1-2.
Step 4.
Place the jumper cap on JP1 pin 2-3 for a few seconds.
Step 5.
Return the jumper cap to pin 1-2.
Step 6.
Plug ATX Power cable into ATX Power connector.
Step 7.
Turn on the system power (PC-> On).
A1
1
1
On board RAID Enable/Disable Setting (JP2)
(AV45GTR only)
JP2 is used to enable/disable IDE RAID controller.
You may choose to place jumper cap on pins 1-2 for enable IDE RAID
controller function; inserting jumper cap on pins 2-3 for disable IDE RAID
controller function.
Pin 2-3
To disable IDE RAID function
Pin 1-2
To enable IDE RAID function
Note:
Please refer to IDE Raid Manual to check information about IDE
RAID Controller.
1
1
A2
1
J P 1
1
J P 2
